here's some tips for the ms fix it in you.... how to fix a leaky faucet....
Remove the cap over the handle, usually a round plastic piece marked H or C, by gently prying it off with the edge of a flat head screwdriver. Underneath that cap will be a screw, which can be loosened by carefully turning counter-clockwise. When this is removed, the whole handle will lift off. Underneath the handle will be a cylindrical metal fixture which can be lifted out. Some models require the metal fixture to be unscrewed before it is removed. After it is lifted out there will be a rubber washer, seal, or O-ring on the bottom of it and this piece is usually the issue. Take the metal unit to the hardware store and purchase another washer, seal or O-ring of the same size. If desired, an extra one can be purchased to replace the one on the other faucet as well since the same factors may be causing wear to the other side, necessitating another repair in the near future. If the decision is made to change both sides, be sure that both valves under the sink are turned off.
While the metal fixture is out of the faucet, look to see if any mineral deposits have formed from its contact with the water. If it has, clean the area carefully using vinegar and a stiff bristled brush.
Install the washer, then replace the metal fixture into the faucet area, reattach the handle by replacing the screw and tightening clockwise, being careful not to over tighten, and slowly turn the water back on to check for the integrity of the unit. When reinstalling the metal fixture, a small amount of silicone based grease or petroleum jelly placed on any visible screw threads can cause smoother operation. If there are no problems, pop the plastic piece back on to cover the head of the screw. you did it!
No comments:
Post a Comment